CAN COMMUNICATION SYSTEM (w/ VSC) > DIAGNOSIS SYSTEM |
| BUS CHECK (COMMUNICATION MALFUNCTION DTC) |
Select "Bus Check" from the "System Select" screen on the intelligent tester.
Select "Communication Malfunction DTC" from the "Bus Check" screen, and then select "Enter".
Select the system of the DTC to be checked and select "Details".
CAN communication system DTC(s) is/are displayed.
| BUS CHECK (COMMUNICATION BUS CHECK) |
Select "Communication Bus Check" from the "Bus Check" screen.
The screen displays the ECUs and sensors that are properly connected to the CAN communication system.
"There is no system connected to the communication bus" is displayed if there are no ECUs or sensors connected to the CAN bus.
| CHECK INSTALLED SYSTEMS (ECUS AND SENSORS) THAT USE CAN COMMUNICATION |
Systems (ECUs and sensors) that use CAN communication vary depending on the vehicle's optional settings. Check which systems (ECUs and sensors) are installed on the vehicle.
| ECU / Sensor name (Tester display) | Installed to |
| Skid control ECU (ABS/VSC/TRC) | All vehicles |
| ECM (Engine) | All vehicles |
| Steering angle sensor (Steering Angle Sensor) | All vehicles |
| Yaw rate sensor (Yaw Rate / Deceleration Sensor) | All vehicles |
| DTC TABLE BY ECU |
SKID CONTROL ECU
| DTC No. | Detection Item |
| U0073 | Control Module Communication Bus OFF |
| U0100 | Lost Communication with ECM / PCM "A" |
| U0123 | Lost Communication with Yaw Rate Sensor Module |
| U0124 | Lost Communication with Lateral Acceleration Sensor Module |
| U0126 | Lost Communication with Steering Angle Sensor Module |
ECM
STEERING ANGLE SENSOR
YAW RATE SENSOR
| DTC COMBINATION TABLE |
Confirm the trouble mode according to the combination of stored DTCs.
| Trouble Mode | U0073 | U0100 | U0123 | U0124 | U0126 |
| Skid control ECU communication stop mode | ○ | ○ | ○ | ○ | ○ |
| Yaw rate sensor communication stop mode | - | - | ○ | ○ | - |
| Steering sensor communication stop mode | - | - | - | - | ○ |
| ECM communication stop mode | - | ○ | - | - | - |