Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM (w/ VSC)

CAN COMMUNICATION SYSTEM (w/ VSC) > ECM Communication Stop Mode


DESCRIPTION


Detection Item
Symptom
Trouble Area
ECM Communication Stop Mode
When either condition below is met:
  1. Engine is not displayed on "Bus Check".
  2. "ECM Communication Stop Mode" in "DTC Combination Table" applies.
  1. Power source or ECM
  2. Harness or connector
  3. ECM

WIRING DIAGRAM


C190793E03


INSPECTION PROCEDURE

HINT:
Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.

1.CHECK HARNESS AND CONNECTOR (ECM - BATTERY AND BODY GROUND)


  1. Disconnect the E5, E6, E7 and E8 ECM connectors.


    C190784E03

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E7-7 (E1) - Body ground
    Always
    Below 1 Ω
    E8-6 (E02) - Body ground
    E8-7 (E01) - Body ground

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    E5-1 (+B) - Body ground
    When battery's positive (+) voltage is applied to terminal MREL
    11 to 14 V
    E6-2 (BATT) - Body ground
    Always

    Result 
    Result
    Proceed to
    OK (for 1KD-FTV)
    A
    OK (for 2KD-FTV)
    B
    NG
    C



B
REPLACE ECM (Click here)

C
REPAIR OR REPLACE HARNESS OR CONNECTOR
A

REPLACE ECM (Click here)