DTC P0622 Generator Field "F" Terminal Circuit |

| DTC No. | DTC Detection Condition | Trouble Area |
| P0622 | No duty signal from terminal M of generator at engine running (1 trip detection logic) |
|

| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0622) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Enter the following menu: Powertrain / Engine / DTC.
Read the DTCs.
| Display (DTC Output) | Proceed to |
| P0622 | A |
| P0622 and other DTCs | B |
|
| ||||
| A | |
| 2.CHECK WHETHER DTC OUTPUT RECURS (DTC P0622) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Enter the following menu: Powertrain / Engine / DTC / Clear.
Clear DTCs.
Start the engine.
Allow the engine to idle for 1 minute or more.
Enter the following menu: Powertrain / Engine / DTC.
Read the DTCs.
| Display (DTC Output) | Proceed to |
| P0622 | A |
| No output | B |
|
| ||||
| A | |
| 3.CHECK HARNESS AND CONNECTOR (IGNITION SWITCH - GENERATOR - ECM) |
![]() |
Disconnect the A8 generator connector.
Turn the ignition switch ON.
Measure the voltage of the generator connector.
| Tester Connection | Specified Condition |
| IG (A8-2) - Body ground | 11 to 14 V |
Turn the ignition switch OFF.
Disconnect the E8 ECM connector.
Measure the resistance of the harness side connectors.
| Tester Connection | Specified Condition |
| M (A8-3) - ALT (E8-8) | Below 1 Ω |
| Tester Connection | Specified Condition |
| M (A8-3) or ALT (E8-8) - Body ground | 10 kΩor higher |
|
| ||||
| OK | |
| 4.INSPECT GENERATOR ASSEMBLY (GENERATOR ROTOR) |
![]() |
Remove the generator assembly (Click here).
Remove the generator rotor assembly (Click here).
Measure the resistance between the slip rings of generator rotor.
| Tester Connection | Condition | Specified Condition |
| Generator slip rings | 20°C(68°F) | 1.85 to 2.25 Ω |
![]() |
Measure the resistance between the slip ring and generator rotor assembly.
| Tester Connection | Specified Condition |
| Generator slip ring - Generator rotor | 10 kΩ or higher |
![]() |
Inspect the slip rings of the generator rotor.
Check that the slip rings are not rough or scored.
Measure the slip ring diameter.
|
| ||||
| OK | |
| 5.REPLACE GENERATOR ASSEMBLY |
Replace the generator assembly (Click here).
|
| ||||
| 6.REPLACE GENERATOR ROTOR ASSEMBLY |
Replace the generator rotor assembly (Click here).
| NEXT | |
| 7.CHECK WHETHER DTC OUTPUT RECURS (DTC P0622) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Enter the following menu: Powertrain / Engine / DTC / Clear.
Clear DTCs.
Start the engine.
Allow the engine to idle for 1 minute or more.
Enter the following menu: Powertrain / Engine / DTC.
Read DTCs.
| Display (DTC Output) | Proceed to |
| P0622 | A |
| No output | B |
|
| ||||
| A | ||
| ||