Home › BODY › EXTERIOR › FRONT BUMPER

FRONT BUMPER > INSTALLATION

for Preparation Click here


HINT:
A bolt without a torque specification is shown in the standard bolt chart (Click here).



1. INSTALL FRONT BUMPER REINFORCEMENT EXTENSION LH (for 4WD and Pre-Runner)
  1. Attach the claws to install the reinforcement extension.



2. INSTALL FRONT BUMPER REINFORCEMENT EXTENSION RH (for 4WD and Pre-Runner)

HINT:
Use the same procedures described for the LH side.



3. INSTALL FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY


B085202E01
  1. Install the reinforcement with the 4 nuts.

    Torque:
    67 N*m{ 683 kgf*cm , 49 ft.*lbf }



4. INSTALL FRONT BUMPER SIDE SUPPORT LH


B085200E01
  1. Attach the 2 claws to install the side support.

  1. Install the screw.



5. INSTALL FRONT BUMPER SIDE SUPPORT RH

HINT:
Use the same procedures described for the LH side.



6. INSTALL FRONT BUMPER COVER


    B206030E01
  1. Put protective tape around the bumper cover.

  1. w/ Fog Light:
    Connect the 2 fog light connectors.

  1. w/ Headlight Cleaner System:
    Connect the headlight cleaner hose.

  1. Attach the 6 claws to install the bumper cover.



    B206029
  1. Install the 7 clips and 2 bolts.



7. INSTALL ENGINE SIDE COVER SUB-ASSEMBLY LH (for 4WD and Pre-Runner)


B206028
  1. Install the side cover with the 3 bolts and 2 clips.

    Torque:
    11.5 N*m{ 117 kgf*cm , 8 ft.*lbf }



8. INSTALL ENGINE SIDE COVER SUB-ASSEMBLY RH (for 4WD and Pre-Runner)

HINT:
Use the same procedures described for the LH side.



9. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH


B206027
  1. Install the splash shield with the 3 clips and 4 screws.



10. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.



11. INSTALL FRONT NO. 1 WHEEL OPENING EXTENSION PAD (for 4WD and Pre-Runner)


B206026
  1. Install the extension pad with the 2 screws.

    HINT:
    Use the same procedures to install the extension pad on the other side.



12. INSTALL RADIATOR GRILLE ASSEMBLY


B206025E01
  1. Put protective tape around the radiator grille.

  1. Attach the 6 claws to install the radiator grille.

  1. Install the 2 screws and 2 clips.