Home › BODY › EXTERIOR › FRONT BUMPER

FRONT BUMPER > DISASSEMBLY

for Preparation Click here



1. REMOVE NO. 1 RADIATOR GRILLE SEAL


B206035E01
  1. Remove the radiator grille seal.



2. REMOVE RADIATOR GRILLE MOULDING


    B210701
  1. Remove the 9 screws and radiator grille moulding.



3. REMOVE LOWER RADIATOR GRILLE MOULDING (for Type B)


B210079
  1. Remove the 16 screws and lower radiator grille moulding.



4. REMOVE RADIATOR GRILLE (OR FRONT PANEL) EMBLEM


    B211266

    1. for Type A:
      Using a screwdriver, detach the 3 claws and remove the emblem from the radiator grille.

      HINT:
      Tape the screwdriver tip before use.



    B207579E03
  1. for Type B:

    1. Using a screwdriver, detach the 3 claws and remove the emblem from the lower radiator grille moulding.

      HINT:
      Tape the screwdriver tip before use.



5. REMOVE RADIATOR GRILLE OR FRONT PANEL NAME PLATE (for 1GR-FE)


B207663E01
  1. Remove the 2 spring nuts.

  1. Using a heat light, heat the name plate.

    Standard:
    Item
    Specified Condition
    Name plate
    20 to 30°C (68 to 86°F)

    NOTICE:
    Do not heat the name plate excessively.

  1. Remove the name plate.

    NOTICE:
    Be careful not to damage the lower radiator grille finish plate.



6. REMOVE FOG LIGHT ASSEMBLY LH (w/ Fog Light)


B206031
  1. Remove the 3 bolts and fog light.



7. REMOVE FOG LIGHT ASSEMBLY RH (w/ Fog Light)

HINT:
Use the same procedures described for the LH side.



8. REMOVE TYPE1 HEADLIGHT WASHER NOZZLE SUB-ASSEMBLY LH (w/ Headlight Cleaner System)


    E119628
  1. Extend the headlight washer nozzle.



    B182297
  1. Detach the 2 claws and remove the washer nozzle.



9. REMOVE TYPE1 HEADLIGHT WASHER NOZZLE SUB-ASSEMBLY RH (w/ Headlight Cleaner System)

HINT:
Use the same procedures described for the LH side.



10. REMOVE HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY LH (w/ Headlight Cleaner System)


    B210371
  1. Disconnect the headlight washer hose.

  1. Remove the bolt.

  1. Detach the 2 claws and remove the headlight washer actuator sub-assembly.



11. REMOVE HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY RH (w/ Headlight Cleaner System)

HINT:
Use the same procedures described for the LH side.



12. REMOVE LOWER RADIATOR GRILLE


B211267
  1. w/ Headlight Cleaner System:
    Detach the 4 clamps and remove the headlight cleaner hose.



    B206032
  1. Detach the 17 claws and guide, and remove the lower radiator grille.



13. REMOVE FRONT BUMPER EXTENSION LH (w/ Over Fender)


    B206033
  1. Using a screwdriver, detach the 6 clips and remove the extension.

    HINT:
    Tape the screwdriver tip before use.



14. REMOVE FRONT BUMPER EXTENSION RH (w/ Over Fender)

HINT:
Use the same procedures described for the LH side.