Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1282/82    Center Differential Lock Position Switch Malfunction (Test Mode DTC)

for Preparation Click here


DESCRIPTION

This circuit monitors whether the transfer is in 2WD or 4WD mode and inputs the signal to the skid control ECU. DTC C1282/82 is deleted when the transfer 4WD position switch sends a transfer 4WD position switch signal or test mode ends.
DTC C1282/82 is output only in test mode.

DTC Code
DTC Detection Condition
Trouble area
C1282/82
Detected only during test mode.
  1. A.D.D. actuator (Differential vacuum actuator assembly)
  2. A.D.D. actuator circuit
  3. Skid control ECU (Brake actuator assembly)

WIRING DIAGRAM


C192939E01


INSPECTION PROCEDURE

NOTICE:
When replacing the brake actuator assembly, perform zero point calibration (Click here).

1.INSPECT SKID CONTROL ECU


    C160263E88
  1. Turn the ignition switch off.

  1. Disconnect the skid control ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    S35-20 (EXI) - Body ground
    1. Ignition switch ON
    2. Transfer shift position H2
    11 to 14 V
    S35-20 (EXI) - Body ground
    1. Ignition switch ON
    2. Transfer shift position L4 or H4
    Below 1.5 V



NG
Go to step 2
OK

REPLACE BRAKE ACTUATOR ASSEMBLY 

2.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - A.D.D. ACTUATOR)

C190843E02

  1. Turn the ignition switch off.

  1. Disconnect the skid control ECU connector.

  1. Disconnect the A.D.D. actuator connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    S35-20 (EXI) - A3-3 (ADD)
    Always
    Below 1 Ω
    S35-20 (EXI) - Body ground
    Always
    10 kΩ or higher
    A3-4 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE DIFFERENTIAL VACUUM ACTUATOR ASSEMBLY