FRONT POWER SEAT MOTOR ASSEMBLY (for Slide) > REMOVAL |
| 1. REMOVE FRONT SEAT ASSEMBLY |
Remove the front seat assembly (Click here).
| 2. REMOVE RECLINING POWER SEAT SWITCH KNOB |
![]() |
Apply protective tape around the cushion shield.
Using a screwdriver, detach the 2 claws and remove the knob.
| 3. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB |
![]() |
Using a screwdriver, detach the 4 claws and remove the knob.
| 4. REMOVE FRONT SEAT CUSHION SHIELD RH |
![]() |
Remove the 2 screws.
![]() |
Remove the 3 screws.
Detach the claw and guide.
Remove the cushion shield.
| 5. REMOVE FRONT POWER SEAT SWITCH |
![]() |
Remove the 3 screws.
Disconnect the connector and remove the switch.
| 6. REMOVE FRONT SEAT CUSHION INNER SHIELD RH |
![]() |
Remove the screw.
Pull the cushion inner shield to detach the claw and guide.
![]() |
Pull the cushion inner shield to detach the claw and remove the cushion inner shield.
| 7. REMOVE FRONT SEAT INNER BELT ASSEMBLY RH |
![]() |
Detach the clamp.
![]() |
Detach the wire harness from the clamp.
Remove the nut and seat belt.
Remove the buckle cover.
| 8. REMOVE SEAT CUSHION COVER WITH PAD |
![]() |
Remove the hog rings.
Detach the hooks and remove the seat cushion cover with pad.

| 9. REMOVE FRONT POWER SEAT MOTOR ASSEMBLY (for Slide) |
![]() |
Detach the 2 wire harness clamps.
Detach the 4 clamps indicated by the arrows in the illustration and remove the seat cushion spring.
![]() |
Remove the 4 bolts and seat cushion frame.
![]() |
Put matchmarks on the seat track rail and sliding unit of the seat frame.
Disconnect the connector.
![]() |
Connect the positive (+) battery terminal to terminal 1 of the power seat motor and the negative (-) battery terminal to terminal 2 and slide the seat to the foremost position.
![]() |
Detach the claw and disconnect the connector from the seat frame.
Loosen the 2 nuts.
![]() |
Connect the positive (+) battery terminal to terminal 2 of the power seat motor and the negative (-) battery terminal to terminal 1 and slide the seat to the rearmost position.
![]() |
Using a 5 mm socket hexagon wrench, remove the 2 bolts.
Using a 4 mm socket hexagon wrench, remove the 4 bolts.
Remove the 2 nuts and front power seat motor assembly with slide cable.
![]() |
Remove the slide cable.