Home › BODY › SEAT › FRONT POWER SEAT MOTOR ASSEMBLY (for Reclining)

FRONT POWER SEAT MOTOR ASSEMBLY (for Reclining) > REMOVAL

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

NOTICE:
If the rear power seat motor has been dropped, replace it with a new one.



1. REMOVE FRONT SEAT ASSEMBLY
  1. Remove the front seat assembly (Click here).



2. REMOVE RECLINING POWER SEAT SWITCH KNOB


    B207076E01
  1. Apply protective tape around the cushion shield.

  1. Using a screwdriver, detach the 2 claws and remove the knob.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB


    B207077E01
  1. Using a screwdriver, detach the 4 claws and remove the knob.

    HINT:
    Tape the screwdriver tip before use.



4. REMOVE FRONT SEAT CUSHION SHIELD RH


    B207078
  1. Remove the 2 screws.



    B207039
  1. Remove the 3 screws.

  1. Detach the claw and guide.

  1. Remove the cushion shield.



5. REMOVE FRONT SEAT CUSHION INNER SHIELD RH


    B207199
  1. Remove the screw.

  1. Pull the cushion inner shield to detach the claw and guide.



    B207617
  1. Pull the cushion inner shield to detach the claw and remove the cushion inner shield.



6. REMOVE SEPARATE TYPE FRONT SEATBACK COVER


    B207085
  1. Remove the hog rings from the wires of the seatback cover. Then roll up the seatback cover.



    B207086
  1. Remove the hog rings and roll up the seatback cloth.



    B207087
  1. Remove the hog rings and detach the strap of the seatback cover. Then roll up the seatback cover.



    B257946
  1. Remove the hog rings from the center of the seatback pad and roll up the seatback cover.



    B207581
  1. Remove the hog rings from the upper part of the seatback pad. Then roll up the seatback cover.



    B207089
  1. Detach the 4 claws and remove the 2 headrest supports.



    B207091
  1. Remove the hog rings and seatback cover.



7. REMOVE SEPARATE TYPE FRONT SEATBACK PAD


    B207090
  1. Remove the seatback pad.



8. REMOVE NO. 1 SEATBACK CLOTH


    B207092
  1. Remove the seatback cloth.



9. REMOVE RECLINING ADJUSTER INSIDE COVER RH


    B207093
  1. Remove the screw.

  1. Detach the claw and remove the cover.



10. REMOVE RECLINING ADJUSTER INSIDE COVER RH


    B171585E02
  1. Remove the screw.

  1. Detach the guide and remove the cover.



11. REMOVE FRONT POWER SEAT MOTOR ASSEMBLY (for Reclining)


    B207267
  1. Detach the 8 hooks and remove the seatback spring.

  1. Disconnect the connector.



    B207099
  1. Detach the 6 claws and remove the push nut from the reclining rod.



    B206606
  1. Remove the reclining rod.



    B206607
  1. Using a 4 mm socket hexagon wrench, remove the 3 bolts and motor.