Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > Brake Warning Light does not Come ON

for Preparation Click here


WIRING DIAGRAM

Refer to Brake Warning Light Remains ON .

INSPECTION PROCEDURE

NOTICE:
When replacing the brake actuator assembly, perform zero point calibration (Click here).

1.CHECK BRAKE WARNING LIGHT
  1. Disconnect the skid control ECU connector.

  1. Turn the ignition switch to on.

  1. Check that the brake warning light comes on.

    OK:
    The brake warning light comes on.



NG
Go to step 2
OK

REPLACE BRAKE ACTUATOR ASSEMBLY 

2.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (BRAKE WARNING LIGHT)
  1. Perform the Active Test of the skid control ECU using the intelligent tester (Click here).

  1. Check the Data List.

    OK:
    "Brake Warning Light" in the Data List changes between ON and OFF when the ON/OFF operation of "Brake Warning Light" in the Active Test is performed.



NG
REPLACE BRAKE ACTUATOR ASSEMBLY
OK

REPLACE COMBINATION METER ASSEMBLY