FRONT BRAKE (for 4WD) > REASSEMBLY |
| 1. INSTALL FRONT DISC |
![]() |
Align the matchmarks and install the disc.
| 2. CHECK DISC RUNOUT |
![]() |
Check the bearing play in the axial direction and the axle hub runout .
Temporarily install the disc with the 6 hub nuts.
Using a dial indicator, measure the disc runout 10 mm (0.39 in.) from the outer edge of the disc.
Remove the hub nuts and disc.
| 3. TEMPORARILY INSTALL FRONT DISC BRAKE BLEEDER PLUG |
Temporarily install the bleeder plug to the cylinder.
Install the cap to the bleeder plug.
| 4. INSTALL PISTON SEAL |
Apply lithium soap base glycol grease to 4 new seals.
Install the 4 seals to the cylinder.
| 5. INSTALL FRONT DISC BRAKE PISTON |
![]() |
Apply lithium soap base glycol grease to the 4 pistons and 4 new cylinder boots.
Install the 4 boots to the pistons.
Install the 4 pistons (with the boots) to the cylinder.
| 6. INSTALL CYLINDER BOOT |
![]() |
Install the boots into the grooves of the cylinder and pistons.
Install the 4 new set rings.