Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK RADIO RECEIVER ASSEMBLY (w/o Steering Pad Switch)

I100979E01

  1. Disconnect the R1 receiver connector.

  2. Measure the resistance and voltage of the wire harness side connector.

    Terminal No. (Symbols)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    R1-7 (GND) - Body ground
    BR - Body ground
    Ground
    Always
    Below 1 Ω
    R1-3 (ACC) - Body ground
    GR - Body ground
    ACC power supply
    Ignition switch ACC
    11 to 14 V
    R1-4 (+B) - Body ground
    L-Y - Body ground
    Battery power supply
    Always
    11 to 14 V
    R1-10 (ILL) - Body ground
    G - Body ground
    Illumination signal
    Light control switch TAIL
    11 to 14 V
    If the results are not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the R1 receiver connector.

  4. Measure the voltage of the connector.

    Terminal No. (Symbols)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    R2-1 (RR+) - R1-7 (GND)*1
    R - BR
    Sound signal (rear right)
    Audio system is operating
    Waveform synchronized with sound is output
    R2-2 (RL+) - R1-7 (GND)*1
    B - BR
    Sound signal (rear left)
    Audio system is operating
    Waveform synchronized with sound is output
    R2-3 (RR-) - R1-7 (GND)*1
    W - BR
    Sound signal (rear right)
    Audio system is operating
    Waveform synchronized with sound is output
    R2-6 (RL-) - R1-7 (GND)*1
    Y - BR
    Sound signal (rear left)
    Audio system is operating
    Waveform synchronized with sound is output
    R1-1 (FR+) - R1-7 (GND)
    LG - BR
    Sound signal (front right)
    Audio system is operating
    Waveform synchronized with sound is output
    R1-2 (FL+) - R1-7 (GND)
    P - BR
    Sound signal (front left)
    Audio system is operating
    Waveform synchronized with sound is output
    R1-5 (FR-) - R1-7 (GND)
    L - BR
    Sound signal (front right)
    Audio system is operating
    Waveform synchronized with sound is output
    R1-6 (FL-) - R1-7 (GND)
    V - BR
    Sound signal (front left)
    Audio system is operating
    Waveform synchronized with sound is output
    R1-8 (ANT) - R1-7 (GND)*2
    B-W - BR
    Antenna amplifier
    Ignition switch ON, radio switch ON and AM or FM radio on
    11 to 14V
    *1: Except 2 speakers
    *2: for Short Pole Type Antenna
    If the result is not as specified, the receiver may have a malfunction.


CHECK RADIO RECEIVER ASSEMBLY (w/ Steering Pad Switch)

E174224E03

  1. Disconnect the R1 receiver connector.

  2. Measure the resistance and voltage according to the value(s) in the table below.

    Terminal No. (Symbols)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    R1-7 (GND) - Body ground
    BR - Body ground
    Ground
    Always
    Below 1 Ω
    R1-3 (ACC) - Body ground
    GR - Body ground
    ACC power supply
    Ignition switch ACC
    11 to 14 V
    R1-4 (+B) - Body ground
    L-Y - Body ground
    Battery power supply
    Always
    11 to 14 V
    R1-10 (ILL) - Body ground
    G - Body ground
    Illumination signal
    Light control switch TAIL
    11 to 14 V
    If the results are not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the R1 receiver connector.

  4. Measure the voltage according to the value(s) in the table below.

    Terminal No. (Symbols)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    R2-1 (RR+) - R1-7 (GND)*1
    R - BR
    Sound signal (rear right)
    Audio system is operating
    Waveform synchronized with sound is output
    R2-2 (RL+) - R1-7 (GND)*1
    B - BR
    Sound signal (rear left)
    Audio system is operating
    Waveform synchronized with sound is output
    R2-3 (RR-) - R1-7 (GND)*1
    W - BR
    Sound signal (rear right)
    Audio system is operating
    Waveform synchronized with sound is output
    R2-6 (RL-) - R1-7 (GND)*1
    Y - BR
    Sound signal (rear left)
    Audio system is operating
    Waveform synchronized with sound is output
    R1-1 (FR+) - R1-7 (GND)
    LG - BR
    Sound signal (front right)
    Audio system is operating
    Waveform synchronized with sound is output
    R1-2 (FL+) - R1-7 (GND)
    P - BR
    Sound signal (front left)
    Audio system is operating
    Waveform synchronized with sound is output
    R1-5 (FR-) - R1-7 (GND)
    L - BR
    Sound signal (front right)
    Audio system is operating
    Waveform synchronized with sound is output
    R1-6 (FL-) - R1-7 (GND)
    V - BR
    Sound signal (front left)
    Audio system is operating
    Waveform synchronized with sound is output
    R12-7 (SW1) - R12-6 (SWG)
    R - L
    Steering pad switch signal
    Steering pad switch not pushed
    4 V or higher
    R12-7 (SW1) - R12-6 (SWG)
    R - L
    Steering pad switch signal
    Steering pad switch Seek+ switch pushed
    0.1 V
    R12-7 (SW1) - R12-6 (SWG)
    R - L
    Steering pad switch signal
    Steering pad switch Seek- switch pushed
    0.9 V
    R12-7 (SW1) - R12-6 (SWG)
    R - L
    Steering pad switch signal
    Steering pad switch Vol+ switch pushed
    1.5 V
    R12-7 (SW1) - R12-6 (SWG)
    R - L
    Steering pad switch signal
    Steering pad switch Vol- switch pushed
    3 V
    R12-8 (SW2) - R12-6 (SWG)
    W - L
    Steering pad switch signal
    Steering pad switch not pushed
    4 V or higher
    R12-8 (SW2) - R12-6 (SWG)
    W - L
    Steering pad switch signal
    Steering pad switch MODE switch pushed
    Below 0.1 V
    R12-3 (SPD) - R1-7 (GND)*2
    V-R - BR
    Speed signal
    Ignition switch ON, drive wheels turned slowly
    Pulse generation
    R1-8 (ANT) - R1-7 (GND)*3
    B-W - BR
    Antenna amplifier
    Ignition switch ON, radio switch ON and AM or FM radio on
    11 to 14V
    *1: Except 2 Speakers
    *2: w/o Cassette Tape Player
    *3: for Short Pole Type Antenna
    If the result is not as specified, the receiver may have a malfunction.