Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)

AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System) > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
Use these procedures to troubleshoot the air conditioning system.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEMS ANALYSIS AND SYMPTOM CHECK

      NEXT


      3.INSPECT BATTERY VOLTAGE

        Standard voltage:
        11 to 14 V

        If the voltage is below 11 V, recharge or replace the battery before proceeding.

      NEXT


      4.CHECK FOR DTC
      1. Check for DTCs and note any codes that are output.

      2. Delete the DTCs.

      3. Recheck for DTCs. Based on the DTCs output above, try to force output of the air conditioning system DTC by simulating the conditions indicated by the DTC.

      4. Result 
        Result
        Proceed to
        DTC is not output
        A
        DTC is output
        B


      B.
      Go to DTC CHART (Click here)
      A


      5.PROBLEM SYMPTOMS TABLE (Click here)
        Result 
        Result
        Proceed to
        Fault is not listed in problem symptoms table
        A
        Fault is listed in problem symptoms table
        B


      B.
      Go to step 7
      A


      6.OVERALL ANALYSIS AND TROUBLESHOOTING
      1. Actuator Check (Click here).

      2. Terminals of ECU (Click here).

      3. On-vehicle Inspection (Click here).


      NEXT


      7.ADJUST, REPAIR OR REPLACE

        NEXT

        END