HEADLIGHT CLEANER CONTROL RELAY > ON-VEHICLE INSPECTION |
| 1. INSPECT HEADLIGHT CLEANER CONTROL RELAY |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 6 (PB) - 4 (E) | Battery voltage is not applied | 10 kΩ or higher |
| Battery positive (+) → Terminal 3 (IG) Battery negative (-) → Terminal 5 (FEWA) | ||
| Battery positive (+) → Terminal 3 (IG) Battery positive (+) → Terminal 2 (H) Battery negative (-) → Terminal 4 (E) | Below 1 Ω for 0.8 to 0.9 seconds, then resistance increases by large amount | |
| Battery positive (+) → Terminal 1 (HDLO) Battery positive (+) → Terminal 3 (IG) Battery negative (-) → Terminal 5 (FRWA) |