Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CLUTCH SWITCH (for LHD)

CLUTCH SWITCH (for LHD) > ADJUSTMENT

for Preparation Click here



1. ADJUST CLUTCH SWITCH ASSEMBLY


    C194217E01
  1. Adjust the switch position so that the clearance labeled A in the illustration, between the clutch switch and cushion, is within the specified range. Then, tighten the adjusting nut.

    Torque:
    16 N*m{ 163 kgf*cm , 12 ft.*lbf }

    Standard:
    Clearance
    Specified Condition
    A
    2.6 to 3.6 mm (0.102 to 0.142 in.)

    NOTICE:
    Before performing the clutch switch assembly adjustment, adjust the pedal free play (Click here).