Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › REAR AIRBAG SENSOR

REAR AIRBAG SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL REAR AIRBAG SENSOR LH


    B214723
  1. Check that the ignition switch is off.

  1. Check that the cable is disconnected from the battery negative (-) terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

  1. Install the rear airbag sensor with the bolt.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

    NOTICE:
    1. If the rear airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
    2. When installing the rear airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

  1. Check that there is no looseness in the installation parts of the rear airbag sensor.

  1. Connect the connector.



2. INSTALL LOWER QUARTER TRIM PANEL LH


B085565E02
  1. Attach the 3 clips and claw to install the trim panel.



3. INSTALL REAR DOOR OPENING TRIM LH


4. INSTALL REAR DOOR SCUFF PLATE LH


B085564E01
  1. Attach the 2 clips and 7 claws to install the scuff plate.



5. INSTALL REAR SEAT ASSEMBLY
  1. Install the rear seat assembly (Click here).



6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


7. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).