Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › REAR AIRBAG SENSOR

REAR AIRBAG SENSOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



2. REMOVE REAR SEAT ASSEMBLY
  1. Remove the rear seat assembly (Click here).



3. REMOVE REAR DOOR SCUFF PLATE LH


B085562E01
  1. Using a screwdriver, detach the 7 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Using a clip remover, detach the 3 clips and remove the scuff plate.



4. REMOVE REAR DOOR OPENING TRIM LH


5. REMOVE LOWER QUARTER TRIM PANEL LH


B085565E02
  1. Using a screwdriver, detach the claw.

    HINT:
    Tape the screwdriver tip before use.

  1. Using a clip remover, detach the 3 clips and remove the trim panel.



6. REMOVE REAR AIRBAG SENSOR LH


    B214723
  1. Remove the bolt and rear airbag sensor.

  1. Disconnect the connector.