FOUR WHEEL DRIVE CONTROL SYSTEM > GENERAL



OUTLINE
  1. A compact and lightweight full-time 2-speed VF4B transfer is used on the 4WD models.

  2. This transfer contains a center differential lock mechanism, which locks the center differential when the driver shifts the transfer shift lever to the LL or HL mode.

  3. A manual operation type 4WD system is used. The optimal drive mode is selected from 3 drive modes (H, HL and LL) in accordance with road surface conditions by operating the transfer shift lever, thus enabling a drive that makes optimal use of drive torque performance.


SPECIFICATION

Drive Type
Full-time
Transfer Gear Ratio
High
1.000
Low
2.566
Reduction Gear Type
Single Pinion Planetary
Center Differential Gear Type
TORSEN*2 Limited Slip Differential (LSD)
Oil Capacity
1.4 Liters (1.5 US qts, 1.2 Imp. qts)
Oil Viscosity
SAE 75W-90
Oil Grade
API GL-5
Weight (Reference)*1
39.7 kg (87.5 lb)

HINT:
*1: Weight shows the figure with the fluid fully filled.
*2: TORSEN is a registered trademark of JTEKT Corporation.


MAIN FEATURES
  1. Drive Mode Features

    Drive Mode
    Transfer Gear Ratio
    Center Differential
    Features
    H
    High
    Free
    Achieves a high level of stability in any speed range and road condition. Using its own movement, the center differential distributes drive torque optimally to the front and rear wheels, and absorbs the rotation difference between them during steering.
    HL
    High
    Lock
    Ensures a high level of driveability in snowy and icy areas, on sand and on rough roads. By switching the center differential to lock, the front and rear torque distribution is stopped and drive torque is accurately transmitted.
    LL
    Low
    Lock
    Used when a large amount of drive torque is especially needed such as when freeing the vehicle from mud. By switching the center differential to lock, the front and rear torque distribution is stopped and drive torque is accurately transmitted.