COOLING SYSTEM > GENERAL



OUTLINE
  1. The cooling system uses a pressurized forced circulation system with a pressurized reservoir tank.

  2. The pressurized reservoir tank is used to prevent the engine coolant from deteriorating upon contact with external air.

  3. A thermostat with a bypass valve is located on the water inlet housing to maintain suitable temperature distribution in the cooling system.

  4. An aluminum radiator core is used for weight reduction.

  5. A water-cooled type engine oil cooler is provided as standard equipment.

  6. A 3-stage temperature-controlled coupling fan, which uses bimetal, controls the fan speed in 3 stages to improve cooling performance and reduce cooling fan noise.



  7. Toyota Genuine Super Long Life Coolant (SLLC) is used.


    W104539E01


    Text in Illustration 
    *1
    Reservoir Tank
    *2
    Thermostat
    *3
    Radiator Assembly
    *4
    Water Pump Assembly
    *a
    To Heater
    *b
    From Heater


SPECIFICATION
  1. Engine Coolant

    1. Toyota Genuine SLLC is used. The maintenance intervals are as shown in the table below:

      Engine Coolant Type
      Toyota Genuine Super Long Life Coolant (SLLC) or similar high quality ethylene glycol based non-silicate, non-amine, non-nitrite and non-borate coolant with long-life hybrid organic acid technology (coolant with long-life hybrid organic acid technology is a combination of low phosphates and organic acids.) Do not use plain water alone.
      Maintenance Intervals
      First Time
      160000 km (100000 miles)
      Subsequent
      Every 80000 km (50000 miles)
      Color
      Pink

      HINT:
      1. SLLC is pre-mixed (40% coolant and 60% deionized water). Therefore, no dilution is needed when SLLC in the vehicle is added or replaced.
      2. If LLC (red-colored) is mixed with SLLC (pink-colored), the interval for LLC (every 40000 km/25000 miles or 24 months whichever comes first) should be used.

  2. Thermostat

    Thermostat Opening Temperature
    80°C to 84°C (176°F to 183°F)