ENGINE COOLANT TEMPERATURE SENSOR > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE V-BANK COVER |
![]() |
Remove the 2 nuts and V-bank cover.
| 3. DISCONNECT NO. 2 VENTILATION HOSE |
![]() |
| 4. REMOVE AIR CLEANER ASSEMBLY |
![]() |
Disconnect the vacuum hose.
Disconnect the MAF meter connector.
Remove the 2 wire harness clamps.
![]() |
Loosen the 2 hose clamps.
Remove the 2 bolts and air cleaner.
| 5. REMOVE THROTTLE BODY |
![]() |
Disconnect the throttle position sensor and control motor connector.
Remove the 4 bolts and throttle body.
Remove the gasket from the intake air surge tank.
| 6. REMOVE INTAKE AIR SURGE TANK |
![]() |
Disconnect the No. 5 water by-pass hose.
![]() |
Disconnect the No. 4 water by-pass hose.
![]() |
Disconnect the purge line hose.
![]() |
Disconnect the No. 1 ventilation hose.
![]() |
Disconnect the purge VSV connector.
Disconnect the VSV connector (for ACIS).
Disconnect the throttle position sensor and control motor connector.
Remove the 3 wire harness clamps and hose clamp.
![]() |
Remove the 3 upper bolts which are used to secure the 2 surge tank stays and throttle body bracket.
![]() |
Using an 8 mm hexagon wrench, remove the 4 bolts.
Remove the 2 nuts, intake air surge tank and gasket.
| 7. REMOVE INTAKE MANIFOLD |
![]() |
Disconnect the 2 water by-pass hoses.
![]() |
Disconnect the purge line hose.
![]() |
Disconnect the ventilation hose.
![]() |
Disconnect the 2 VSV connectors.
Disconnect the throttle body with motor connector.
Separate the 3 wire harness clamps and hose clamp.
![]() |
Remove the 2 bolts and throttle body bracket.
![]() |
Remove the bolt and oil baffle plate.
Remove the 4 bolts and 2 surge tank stays.
![]() |
Remove the 2 nuts.
Using an 8 mm hexagon socket wrench, remove the 4 bolts, intake air surge tank and gasket.
| 8. REMOVE ENGINE COOLANT TEMPERATURE SENSOR |
![]() |
Disconnect the sensor connector.
Remove the sensor.
Remove the gasket from the sensor.