Home › ENGINE ยท 2TR-FE › STARTING › STARTER

STARTER > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE FRONT FENDER SEAL
  1. Remove the 5 clips and seal.



3. DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY


G034223E01
  1. Remove the 2 bolts and disconnect the release cylinder.



4. REMOVE STARTER ASSEMBLY


    G039103E03
  1. Disconnect the starter connector.

  1. Disconnect the terminal cap.

  1. Remove the nut and disconnect the starter wire.

  1. Remove the 2 bolts and starter.