Home › ENGINE ยท 2KD-FTV › STARTING › STARTER (for 2.2 kW Type)

STARTER (for 2.2 kW Type) > DISASSEMBLY

for Preparation Click here



1. REMOVE MAGNET STARTER SWITCH ASSEMBLY


    A121919
  1. Remove the nut, and then disconnect the lead wire from terminal C.



    A121920
  1. Using a T25 "TORX" socket wrench, remove the 3 screws holding the magnet starter switch assembly to the starter drive housing.

  1. Remove the magnet starter switch assembly.

  1. Remove the return spring.



    A121921E02
  1. Remove the plunger from the pinion drive lever.
    Text in Illustration 
    *1
    Plunger
    *2
    Pinion Drive Lever



2. REMOVE STARTER YOKE ASSEMBLY


    A121922
  1. Remove the 2 bolts and starter yoke assembly from the starter drive housing.

  1. Remove the cover ring from the planet carrier.



    A121923
  1. Remove the plate from the planet carrier.



3. REMOVE STARTER BRUSH HOLDER ASSEMBLY

NOTICE:
Do not drop the starter armature assembly.

  1. Hold the starter yoke between aluminum plates in a vise.

    NOTICE:
    Do not damage the starter yoke assembly.



    A121924
  1. Remove the 2 screws and starter commutator end frame cover from the starter commutator end frame.

  1. Remove the seal ring.



    A121925E02
  1. Remove the slotted washer.
    Text in Illustration 
    *1
    Slotted Washer



    A121926E02
  1. Remove the washer.

  1. Remove the starter commutator end frame from the starter yoke assembly.
    Text in Illustration 
    *1
    Washer
    *2
    Commutator End Frame



    A121927E03
  1. Remove the starter brush holder from the starter armature assembly.
    Text in Illustration 
    *1
    Rubber Part
    *2
    Brush Holder
    *3
    Spring

    NOTICE:
    Do not pull on the rubber part.



4. REMOVE STARTER ARMATURE ASSEMBLY


    A105361E04
  1. Remove the starter armature from the starter yoke.
    Text in Illustration 
    *1
    Starter Yoke
    *2
    Starter Armature



5. REMOVE STARTER CLUTCH SUB-ASSEMBLY


    A122390
  1. Remove the 3 planetary gears from the planet carrier.



    A121928E03
  1. Remove the starter clutch sub-assembly, pinion drive lever and cover from the starter drive housing.
    Text in Illustration 
    *1
    Pinion Drive Lever
    *2
    Cover
    *3
    Starter Drive Housing
    *4
    Starter Clutch Sub-assembly



    A121929E02
  1. Using a screwdriver, move the pinion stop collar to the starter clutch.
    Text in Illustration 
    *1
    Collar
    *2
    Clutch



    A121930E02
  1. Using a screwdriver, remove the snap ring.
    Text in Illustration 
    *1
    Snap Ring
    *2
    Collar



    A105365
  1. Remove the pinion stop collar and starter clutch sub-assembly from the planet carrier shaft.



6. REMOVE PLANET CARRIER SHAFT SUB-ASSEMBLY


    A105364
  1. Using 2 screwdrivers and a hammer, tap off the snap ring.

  1. Remove the washer from the planet carrier shaft.



    A117267E02
  1. Remove the planet carrier shaft from the planet carrier.
    Text in Illustration 
    *1
    Planet Carrier
    *2
    Planet Carrier Shaft

  1. Remove the intermediate sealing and the 3 damper rubbers from the planet carrier.