Home › BODY › INSTRUMENT PANEL › UPPER INSTRUMENT PANEL

UPPER INSTRUMENT PANEL > REASSEMBLY

for Preparation Click here


HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.



1. INSTALL COOLER (SOLAR SENSOR) THERMISTOR (for Automatic Air Conditioning System)


E175029
  1. Connect the connector, and then push in the solar sensor.



2. INSTALL LIGHT CONTROL SWITCH HOLE COVER (w/ Automatic Light Control System)
  1. Attach the guide and 2 claws to install the light control switch hole cover.



3. INSTALL AUTOMATIC LIGHT CONTROL SENSOR (w/ Automatic Light Control System)
  1. Attach the 2 claws to install the automatic light control sensor.



4. INSTALL NO. 2 INSTRUMENT PANEL CUSHION


B278067
  1. Clean the instrument panel surface.

  1. Align a new No. 2 instrument panel cushion with the markings on the upper instrument panel and install the No. 2 instrument panel cushion to the position shown in the illustration using double-sided tape.



5. INSTALL NO. 3 INSTRUMENT PANEL CUSHION


B206460
  1. Clean the instrument panel surface.

  1. Align a new No. 3 instrument panel cushion with the markings on the upper instrument panel and install the No. 3 instrument panel cushion to the position shown in the illustration using double-sided tape.



6. INSTALL NO. 4 INSTRUMENT PANEL CUSHION


B206458
  1. Clean the instrument panel surface.

  1. Align a new No. 4 instrument panel cushion with the markings on the upper instrument panel and install the No. 4 instrument panel cushion to the position shown in the illustration using double-sided tape.



7. INSTALL INSTRUMENT PANEL CUP HOLDER SUB-ASSEMBLY

HINT:
Use the same procedure for both instrument panel cup holders.

  1. Install the instrument panel cup holder with the 3 screws <B>.



8. INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY
  1. Attach the 4 claws to install the No. 2 instrument panel register.



9. INSTALL NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY

HINT:
Use the same procedure described for the No. 2 instrument panel register.



10. INSTALL METER MOUNTING BRACKET
  1. Install the meter mounting bracket with the screw <B>.