STEERING ANGLE SENSOR (w/ VSC) > INSTALLATION |
| 1. INSTALL SPIRAL CABLE SUB-ASSEMBLY (STEERING ANGLE SENSOR) |
Check that the front wheels are facing straight ahead.
Set the turn signal switch to the neutral position.
Install the spiral cable.
Connect the connectors to the spiral cable.
| 2. INSTALL UPPER STEERING COLUMN COVER |
| 3. INSTALL LOWER STEERING COLUMN COVER |
![]() |
Install the lower cover with the 3 screws.
| 4. ADJUST SPIRAL CABLE |
![]() |
Slowly rotate the spiral cable counterclockwise by hand until it feels firm.
![]() |
Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.
| 5. INSTALL STEERING WHEEL ASSEMBLY |
![]() |
Align the matchmarks on the steering wheel and main shaft.
Install the steering set nut.
| 6. INSTALL STEERING PAD |
![]() |
Support the steering pad with one hand.
Connect the connector to the steering pad.
Connect the horn connector.
Confirm that the groove along the circumference of the "TORX" screw is attached to the screw case and place the steering pad onto the steering wheel.
Using a T30 "TORX" socket wrench, tighten the 2 screws.
| 7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 8. CHECK SRS WARNING LIGHT |
Check the SRS warning light (Click here).