Home › BRAKE › BRAKE CONTROL › STEERING ANGLE SENSOR (w/ VSC)

STEERING ANGLE SENSOR (w/ VSC) > REMOVAL

for Preparation Click here


CAUTION:
Be sure to read the "PRECAUTION" thoroughly before servicing (Click here).



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD


3. REMOVE STEERING PAD


    B290079E01
  1. Using a T30 "TORX" socket wrench, loosen the 2 screws until the groove along the screw circumference catches on the screw case.
    Text in Illustration 
    *1
    Screw Case



    B277210
  1. Pull out the steering pad from the steering wheel as shown in the illustration. Then support the steering pad with one hand.

    NOTICE:
    When removing the steering pad, do not pull the airbag wire harness.

  1. Disconnect the horn connector.

  1. Disconnect the connector and remove the steering pad.

    NOTICE:
    When handling the airbag connector, do not damage the airbag wire harness.



4. REMOVE STEERING WHEEL ASSEMBLY
  1. Remove the steering wheel set nut.



    G034428E02
  1. Place matchmarks on the steering wheel and main shaft.

  1. Using SST, remove the steering wheel.

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05021)



5. REMOVE LOWER STEERING COLUMN COVER


    C238860
  1. Remove the 3 screws and lower cover.



6. REMOVE UPPER STEERING COLUMN COVER


7. REMOVE SPIRAL CABLE SUB-ASSEMBLY (STEERING ANGLE SENSOR)


B110259E02
  1. Disconnect the connectors from the spiral cable.

    NOTICE:
    When handling the airbag connector, do not damage the airbag wire harness.

  1. Detach the 3 claws and remove the spiral cable.