STEERING ANGLE SENSOR (w/ VSC) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD |
| 3. REMOVE STEERING PAD |
![]() |
Using a T30 "TORX" socket wrench, loosen the 2 screws until the groove along the screw circumference catches on the screw case.
| *1 | Screw Case |
![]() |
Pull out the steering pad from the steering wheel as shown in the illustration. Then support the steering pad with one hand.
Disconnect the horn connector.
Disconnect the connector and remove the steering pad.
| 4. REMOVE STEERING WHEEL ASSEMBLY |
Remove the steering wheel set nut.
![]() |
Place matchmarks on the steering wheel and main shaft.
Using SST, remove the steering wheel.
| 5. REMOVE LOWER STEERING COLUMN COVER |
![]() |
Remove the 3 screws and lower cover.
| 6. REMOVE UPPER STEERING COLUMN COVER |
| 7. REMOVE SPIRAL CABLE SUB-ASSEMBLY (STEERING ANGLE SENSOR) |
![]() |
Disconnect the connectors from the spiral cable.
Detach the 3 claws and remove the spiral cable.