ECD SYSTEM > Starter Signal Circuit |
| 1.READ VALUE USING INTELLIGENT TESTER (STARTER SIG) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the intelligent tester ON.
Enter the following menus: Powertrain / Engine and ECT / Data List / Starter Signal.
Read the values.
| Ignition Switch Position | Starter SIG |
| ON | OFF |
| START | ON |
|
| ||||
| NG | |
| 2.CHECK WIRE HARNESS (ECM - STARTER RELAY (Marking: ST)) |
![]() |
Disconnect the E4 ECM connector.
Remove the starter relay from the engine room relay block.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| Relay block starter relay terminal 1 - E4-7 (STA) | Below 1 Ω |
| Relay block starter relay terminal 1 or E4-7 (STA) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||