Home › BRAKE › BRAKE › VACUUM PUMP (for 5L-E)

VACUUM PUMP (for 5L-E) > ON-VEHICLE INSPECTION

for Preparation Click here



1. OPERATION CHECK
  1. Disconnect the vacuum hose from the vacuum pump.



    C106115E02
  1. Connect the hose of a vacuum gauge to the pump.

  1. Insert a plug into the other hose of the gauge.

  1. Start the engine and warm it up for more than 2 minutes.

  1. With the engine idling, measure the negative pressure of the pump.

    Standard negative pressure:
    More than 86.7 kPa (650 mmHg, 26 in.Hg)

  1. Remove the gauge from the pump.

  1. Connect the hose to the pump with the clip.