Home › ENGINE ยท 5L-E › ENGINE CONTROL SYSTEM › ECM

ECM > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag activation.



2. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY


B278058E01
  1. Slightly bend the upper part of the glove compartment door to release the 2 stoppers and open the glove compartment door until it is horizontal.
    Text in Illustration 
    *1
    Stopper



    B278059E01
  1. Pull the glove compartment door toward the rear of the vehicle to detach the 2 hinges and remove the glove compartment door.
    Text in Illustration 
    *1
    Hinge



3. REMOVE 4WD CONTROL ECU


    A114289
  1. Disconnect the connector.

  1. Remove the bolt and ECU.



4. REMOVE ECM
  1. Disconnect the 4 connectors.



    A114276
  1. Remove the bolt, 2 nuts and ECM.



5. REMOVE NO. 1 ECM BRACKET


    A272508
  1. Remove the 3 screws and bracket.



6. REMOVE NO. 2 ECM BRACKET


    A191417
  1. Remove the 2 screws and bracket.