Home › ENGINE ยท 2TR-FE › ENGINE CONTROL SYSTEM › ACCELERATOR PEDAL ROD

ACCELERATOR PEDAL ROD > INSTALLATION

for Preparation Click here



1. INSTALL ACCELERATOR PEDAL ROD


    A099092E01
  1. NOTICE:
    This accelerator pedal does not require lubrication.
    Do not apply oil or other lubrication to the accelerator pedal rod.
    If applied, the accelerator pedal rod must be replaced.

    Install the accelerator pedal rod with the 2 bolts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

  1. Connect the accelerator pedal position sensor connector.



2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL