Home › ENGINE ยท 2TR-FE › ENGINE CONTROL SYSTEM › CRANKSHAFT POSITION SENSOR

CRANKSHAFT POSITION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL CRANKSHAFT POSITION SENSOR


    A099147E04
  1. Apply a light coat of engine oil to the O-ring of the sensor.

  1. Install the sensor with the bolt.

    Torque:
    8.5 N*m{ 87 kgf*cm , 75 in.*lbf }

  1. Install the connector to the connector bracket.

  1. Attach the harness clamp.

  1. Connect the sensor connector.



2. INSTALL NO. 1 COMPRESSOR MOUNTING BRACKET

NOTICE:
Install the compressor mounting bracket exactly as described in the procedures below to properly secure and prevent damage to the drive belt.



    A330624
  1. Temporarily install the compressor mounting bracket with the 3 bolts.

    HINT:
    Temporarily install the compressor mounting bracket with the 3 bolts so that the bracket can be moved by hand.



  1. Push the compressor mounting bracket toward the cylinder block as shown in the illustration and tighten bolt B.


    A332516E01

    Torque:
    45 N*m{ 459 kgf*cm , 33 ft.*lbf } for bolt B

    HINT:
    Make sure there is no clearance between the cylinder block and compressor mounting bracket as shown in the illustration.



    A332517E01
  1. Uniformly tighten the 4 bolts in the order shown in the illustration.

    Torque:
    45 N*m{ 459 kgf*cm , 33 ft.*lbf } for bolt A
    24.5 N*m{ 250 kgf*cm , 18 ft.*lbf } for bolt C



3. INSTALL COOLER COMPRESSOR ASSEMBLY


G039332E02
  1. Temporarily install the compressor with the bolt labeled A.

  1. Install the compressor by tightening the 4 bolts in the order shown in the illustration.

    Torque:
    25 N*m{ 255 kgf*cm , 18 ft.*lbf }

    NOTICE:
    In order to prevent misalignment, which causes belt rattle, tightening of the bolts must be performed in the order shown.

  1. Connect the compressor connector.



    A099198E02
  1. Install the suction hose with the 2 bolts.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



4. INSTALL DRIVE BELT


    A097752E04
  1. Install the drive belt to all the pulleys except the drive belt tensioner pulley.

  1. Use the hexagon-shaped part indicated by the arrow in the illustration to move the tensioner pulley downward and then install the drive belt to the tensioner pulley.

    NOTICE:
    1. The backside of the drive belt should face the tensioner pulley.
    2. Check that the drive belt is properly set to each pulley.



    G038479E01
  1. After a new belt has been installed, check that the tensioner indicator mark is within range A shown in the illustration.



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL