Home › ENGINE ยท 1GR-FE › ENGINE CONTROL SYSTEM › CRANKSHAFT POSITION SENSOR

CRANKSHAFT POSITION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL CRANKSHAFT POSITION SENSOR


    A076417E01
  1. Apply a light coat of engine oil to the O-ring of the sensor.

  1. Install the sensor with the bolt.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. Connect the sensor connector.



2. INSTALL COOLER COMPRESSOR ASSEMBLY


    A112978E01
  1. Temporarily install the compressor with the bolt labeled A.

  1. Install the compressor completely by tightening the 4 bolts in the order shown in the illustration.

    Torque:
    25 N*m{ 255 kgf*cm , 18 ft.*lbf }

    NOTICE:
    In order to prevent misalignment, which causes belt rattle, tightening of the bolts must be performed in the order shown.

  1. Connect the compressor connector.



    A112977
  1. Connect the suction hose with the 2 bolts.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



3. INSTALL GENERATOR ASSEMBLY


A194920
  1. Install the generator with the 2 bolts.

    Torque:
    43 N*m{ 438 kgf*cm , 32 ft.*lbf }

  1. Install the generator wire with the nut and 2 bolts.

    Torque:
    9.8 N*m{ 100 kgf*cm , 87 in.*lbf } for nut
    12.5 N*m{ 127 kgf*cm , 9 ft.*lbf } for bolt

  1. Install the terminal cap.

  1. Connect the generator connector.



4. INSTALL DRIVE BELT


    A076442E03
  1. While turning the belt tensioner counterclockwise, align its holes, and then insert a bar with a diameter of 6 mm (0.24 in.) into the holes to fix the belt tensioner.



  1. Install the V-ribbed belt.

    HINT:
    A113028E03
    If it is hard to install the V-ribbed belt, perform the following procedure.


    1. Put the V-ribbed belt on everything except the PS pump as shown in the illustration.

    2. While releasing the belt tension by turning the belt tensioner counterclockwise, put the V-ribbed belt on the PS pump.

  1. While turning the belt tensioner counterclockwise, remove the pin.



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL