Home › ENGINE ยท 1GR-FE › ENGINE CONTROL SYSTEM › CRANKSHAFT POSITION SENSOR

CRANKSHAFT POSITION SENSOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE DRIVE BELT


    A076441E01
  1. While releasing the belt tension by turning the belt tensioner counterclockwise, remove the V-ribbed belt from the belt tensioner.



3. REMOVE GENERATOR ASSEMBLY


A194920
  1. Disconnect the terminal cap.

  1. Remove the 2 bolts, nut and generator wire.

  1. Disconnect the generator connector.

  1. Remove the 2 bolts and generator.



4. DISCONNECT COOLER COMPRESSOR ASSEMBLY


    A112977
  1. Remove the 2 bolts and disconnect the suction hose from the engine.



    A112978
  1. Disconnect the cooler compressor connector.

  1. Remove the 4 bolts and disconnect the compressor from the engine.

  1. Support the cooler compressor securely.



5. REMOVE CRANKSHAFT POSITION SENSOR


    A076417E01
  1. Disconnect the sensor connector.

  1. Remove the bolt and sensor.