Home › TRANSMISSION ยท A750F AUTOMATIC TRANSMISSION › AUTOMATIC TRANSMISSION SYSTEM

AUTOMATIC TRANSMISSION SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
*: Use the intelligent tester.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS

      NEXT


      3.INSPECT BATTERY VOLTAGE

        Standard voltage:
        11 to 14 V

        If the voltage is below 11 V, recharge or replace the battery before proceeding.

      NEXT


      4.CONNECT INTELLIGENT TESTER TO DLC3*

        NEXT


        5.CHECK AND CLEAR DTC AND FREEZE FRAME DATA*
        1. Refer to the DTC check / clear (Click here).


        NEXT


        6.VISUAL INSPECTION

          NEXT


          7.SETTING CHECK MODE DIAGNOSIS*
          1. Refer to the check mode procedure (Click here).


          NEXT


          8.PROBLEM SYMPTOM CONFIRMATION
          1. Refer to the road test (Click here).

          2. Result:
            Result
            Proceed to
            Symptom does not occur
            A
            Symptom occurs
            B



          B.
          GO TO STEP 10
          A


          9.SYMPTOM SIMULATION
          1. Refer to the electronic circuit inspection procedure (Click here).


          NEXT


          10.DTC CHECK*
          1. Refer to the DTC check / clear (Click here).

          2. Result:
            Result
            Proceed to
            DTC is not output
            A
            DTC is output
            B



          B.
          GO TO STEP 19
          A


          11.BASIC INSPECTION
          1. Refer to the automatic transmission fluid (Click here).

          2. Refer to the park / neutral position switch (Click here).

          3. Refer to the floor shift assembly (Click here).



          NG.
          GO TO STEP 20
          OK


          12.MECHANICAL SYSTEM TESTS
          1. Refer to the mechanical system tests (Click here).



          NG.
          GO TO STEP 17
          OK


          13.HYDRAULIC TEST
          1. Refer to the hydraulic test (Click here).



          NG.
          GO TO STEP 17
          OK


          14.MANUAL SHIFTING TEST
          1. Refer to the manual shifting test (Click here).



          NG.
          GO TO STEP 16
          OK


          15.PROBLEM SYMPTOMS TABLE CHAPTER 1
          1. Refer to the problem symptoms table (Click here).



          NG.
          GO TO STEP 20
          OK


          16.PROBLEM SYMPTOMS TABLE CHAPTER 2
          1. Refer to the problem symptoms table (Click here).



          NG.
          GO TO STEP 18
          OK


          17.PROBLEM SYMPTOMS TABLE CHAPTER 3
          1. Refer to the problem symptoms table (Click here).


          NG


          18.PART INSPECTION


            NG.
            GO TO STEP 20
            OK


            19.DTC CHART
            1. Refer to the diagnostic trouble code chart (Click here).


            NEXT


            20.CIRCUIT INSPECTION

              NEXT


              21.REPAIR OR REPLACE

                NEXT


                22.CONFIRMATION TEST

                  NEXT

                  END