AUTOMATIC TRANSMISSION SYSTEM (for 1KD-FTV) > CHECK MODE PROCEDURE |
| CHECK MODE PROCEDURE |
![]() |
Make sure that the following conditions are met:
Battery voltage 11 V or more.
Throttle valve fully closed.
Shift lever on P or N.
A/C off.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and push the tester main switch on.
Enter the following menus: Powertrain / ECT / Check Mode.
![]() |
Make sure the MIL flashes as shown in the illustration.
Start the engine (the MIL should turn off).
Simulate the conditions of the malfunction described by the customer.
Check the DTC(s) and freeze frame data using the intelligent tester.
After checking the DTCs, inspect the appropriate circuits (Click here).