DTC P0717 Turbine Speed Sensor Circuit No Signal |
| DTC Code | DTC Detection Condition | Trouble Area |
| P0717 | All conditions are met for 5 seconds or more (2-trip detection logic): (a) Transmission input shaft speed is 300 rpm or less. (b) Transmission output shaft speed is 500 rpm or more. (c) Park/neutral position switch R input signal is off. |
|
| Terminal No. (Symbol) | Tool Setting | Condition | Specified Condition |
| E10-34 (NC0+) - E10-26 (NC0-) | 5 V/DIV., 0.5 msec./DIV. | Engine idling (shift lever in P or N) | Refer to illustration |


| DATA LIST |
Warm up the engine.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / Data List.
According to the display on the tester, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| SPD (NC0) | Input shaft speed/ Min.: 0 rpm Max.: 12750 rpm |
| Data is displayed in increments of 50 rpm. |
| 1.INSPECT SPEED SENSOR NC0 INSTALLATION |
![]() |
Check the speed sensor NC0 installation.
| *a | CORRECT |
| *b | INCORRECT |
|
| ||||
| OK | |
| 2.INSPECT SPEED SENSOR NC0 |
![]() |
Disconnect the T7 speed sensor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | 20°C (68°F) | 560 to 680 Ω |
| *a | Component without harness connected (Speed Sensor NC0) |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (SPEED SENSOR NC0 - ECM) |
![]() |
Disconnect the E10 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E10-34 (NC0+) - E10-26 (NC0-) | 20°C (68°F) | 560 to 680 Ω |
| E10-34 (NC0+) - Body ground | Always | 10 kΩ or higher |
| E10-26 (NC0-) - Body ground | Always | 10 kΩ or higher |
| *a | Rear view of wire harness connector (to ECM) |
|
| ||||
| OK | ||
| ||