Home › ENGINE · 1GR-FE › ENGINE CONTROL SYSTEM › FUEL PUMP RELAY

FUEL PUMP RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE FUEL PUMP RELAY (Marking: F/PMP)
  1. Remove the engine room relay block cover.

  1. Remove the fuel pump from the engine room junction block.



3. INSPECT FUEL PUMP RELAY


A087121E01
  1. Measure the resistance of the fuel pump relay.

    Standard resistance:
    Tester Connection
    Specified Condition
    3 - 4
    Below 1 Ω
    3 - 5
    10 kΩ or higher
    3 - 4
    10 kΩ or higher
    (when battery voltage is applied to terminals 1 and 2)
    3 - 5
    Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)

    If the result is not as specified, replace the relay.



4. INSTALL FUEL PUMP RELAY


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL