Home › BODY ELECTRICAL › LIGHTING › LIGHTING SYSTEM

LIGHTING SYSTEM > Diagnosis Circuit

for Preparation Click here


DESCRIPTION

The headlight leveling ECU outputs DTC information to the intelligent tester via this circuit.

WIRING DIAGRAM


E227422E02


INSPECTION PROCEDURE

HINT:
After replacing the headlight leveling ECU, initialization of the ECU is necessary (Click here).

1.CHECK HARNESS AND CONNECTOR (DLC3 - HEADLIGHT LEVELING ECU ASSEMBLY)
  1. Disconnect the H17 headlight leveling ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H17-15 (PRST) - D3-7 (SIL)
    Always
    Below 1 Ω
    H17-15 (PRST) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE HEADLIGHT LEVELING ECU ASSEMBLY (Click here)