VVT SENSOR > INSTALLATION |
| 1. INSTALL VVT SENSOR (for Bank 2) |
![]() |
Install the sensor with the bolt.
Connect the sensor connector.
![]() |
Connect the No. 4 and No. 5 water by-pass hoses.
| 2. INSTALL VVT SENSOR (for Bank 1) |
![]() |
Install the sensor with the bolt.
Connect the sensor connector.
| 3. REMOVE AIR CLEANER ASSEMBLY |
| 4. REMOVE NO. 2 VENTILATION HOSE |
| 5. ADD ENGINE COOLANT |
Tighten all the plugs and fill the radiator with TOYOTA Super Long Life Coolant (SLLC).
Fill the radiator reservoir with TOYOTA Super Long Life Coolant (SLLC) to the F line.
Install the radiator cap.
Bleed air from the cooling system.
Warm up the engine until the thermostat opens.
While the thermostat is open, circulate the coolant for several minutes.
Maintain the engine speed at 2,500 to 3,000 rpm.
Press the inlet and outlet radiator hoses several times by hand to bleed air.
Stop the engine and wait until the coolant cools down to ambient temperature.
![]() |
Check the coolant level in the radiator reservoir.
If the coolant level is below the L line, add SLLC to the reservoir F line.
| 6. CHECK FOR ENGINE COOLANT LEAKS |
Check for engine coolant leaks (Click here).
| 7. INSTALL V-BANK COVER |
Install the V-bank cover with the 2 nuts.
| 8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |