DTC C1429 Open or Short in Brake Pedal Load Sensing Switch |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1429 | An open or short in the brake pedal load sensing switch continues for 0.3 seconds or more. |
|

| 1.READ VALUE USING INTELLIGENT TESTER (BRAKE PEDAL LOAD SENSING SW) |
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Brake Pedal Load Sensing SW | Brake pedal load sensing switch / ON or OFF | ON: Brake pedal depressed beyond specified point OFF: Brake pedal not depressed beyond specified point | - |
Check that the brake pedal load sensing switch display observed on the intelligent tester changes according to the brake pedal operation.
|
| ||||
| OK | |
| 2.RECONFIRM DTC |
Clear the DTC (Click here).
Turn the ignition switch off.
Start the engine.
Depress the brake pedal several times.
Check if the same DTC is output (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | ||
| ||
| 3.INSPECT BRAKE PEDAL LOAD SENSING SWITCH |

| *1 | Brake Pedal Load Sensing Switch | *2 | Brake with Switch Pedal Sub-assembly |
| *a | Component without harness connected (Brake Pedal Load Sensing Switch) | *b | Brake Pedal Released (Closed) |
| *c | Brake Pedal Depressed (Open) | - | - |
Turn the ignition switch off.
Disconnect the brake pedal load sensing switch (brake with switch pedal sub-assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 2 - 1 | Brake pedal depressed | 950 to 1050 Ω |
| Brake pedal released | 203 to 223 Ω |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - BRAKE PEDAL LOAD SENSING SWITCH) |
Turn the ignition switch off.
Disconnect the skid control ECU (brake actuator assembly) connector.
Disconnect the brake pedal load sensing switch (brake with switch pedal sub-assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S25-27 (FSW+) - B13-2 | Always | Below 1 Ω |
| S25-27 (FSW+) - Body ground | Always | 10 kΩ or higher |
| B13-1 - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||