OIL FILTER > REPLACEMENT |
| 1. DRAIN ENGINE OIL |
Remove the oil filler cap.
Remove the engine under cover.
Remove the oil pan drain plug and drain the engine oil into a container.
| 2. REMOVE OIL FILTER WHEN NOT USING DRAIN HOSE |
![]() |
Remove the drain pipe cap.
While removing the oil filter with SST, collect the oil from the oil filter in a container.
Install the drain pipe cap.
Clean the container.
| 3. REMOVE OIL FILTER WHEN USING DRAIN HOSE |
Remove the drain pipe cap.
![]() |
Connect a drain hose to the oil filter bracket.
Feed the drain hose down through the engine under cover, and put a container beneath the drain hose to collect the oil from the oil filter.
![]() |
Using SST, remove the oil filter.
Remove the drain hose and install the drain pipe cap.
Clean the container.
| 4. INSTALL OIL FILTER |
![]() |
Check and clean the oil filter installation surface.
Apply clean engine oil to the gasket of a new oil filter.
Lightly screw the oil filter into place by hand. Tighten it until the gasket contacts the seat.
![]() |
Using SST, tighten the oil filter an additional 3/4 turn.
| 5. ADD ENGINE OIL |
Clean and install the oil drain plug with a new gasket.
![]() |
Add fresh engine oil.
| Item | Specified Condition |
| Drain and refill with oil filter change | 5.5 liters (5.8 US qts, 4.8 Imp. qts) |
| Drain and refill without oil filter change | 5.2 liters (5.5 US qts, 4.6 Imp. qts) |
| Dry fill | 6.6 liters (7.0 US qts, 5.8 Imp. qts) |
Install the oil filler cap.
| 6. CHECK FOR ENGINE OIL LEAKS |
| 7. CHECK ENGINE OIL LEVEL |
Warm up the engine, stop the engine and wait 5 minutes. The oil level should be between the dipstick's low and full level marks.
If low, check for leakage and add oil up to the full level mark.