ENGINE UNIT > REPLACEMENT |
| 1. REPLACE TIMING CHAIN COVER OIL SEAL |
![]() |
Place the timing chain cover on wooden blocks.
Using a screwdriver with its tip taped, pry out the oil seal.
![]() |
Using SST and a hammer, tap in a new oil seal until its surface is flush with the timing chain cover edge.
Apply a light coat of MP grease to the lip of the oil seal.
| 2. REPLACE ENGINE REAR OIL SEAL |
![]() |
Place the oil seal retainer on wooden blocks.
Using a screwdriver with its tip taped and hammer, tap out the oil seal.
![]() |
Place the oil seal retainer on wooden blocks.
Using SST and a hammer, tap in the oil seal until its surface is flush with the oil seal retainer edge.
| 3. REPLACE INTAKE VALVE GUIDE BUSH |
![]() |
Heat the cylinder head to 80 to 100°C (176 to 212°F).
![]() |
Place the cylinder head on wooden blocks.
Using SST and a hammer, tap out the guide bush.
![]() |
Using a caliper gauge, measure the bush bore diameter of the cylinder head.
Select a new guide bush (STD or O/S 0.05).
| Bush Bore Diameter | Bush Size |
| 10.285 to 10.306 mm (0.4049 to 0.4057 in.) | Use STD |
| 10.335 to 10.356 mm (0.4069 to 0.4077 in.) | Use O/S 0.05 |
![]() |
Heat the cylinder head to 80 to 100°C (176 to 212°F).
![]() |
Place the cylinder head on wooden blocks.
Using SST and a hammer, tap in a new valve guide bush to the specified protrusion height.
Using a sharp 5.5 mm reamer, ream the valve guide bush to obtain the standard specified clearance.
| 4. REPLACE EXHAUST VALVE GUIDE BUSH |
![]() |
Heat the cylinder head to 80 to 100°C (176 to 212°F).
Place the cylinder head on wooden blocks.
Using SST and a hammer, tap out the guide bush.
![]() |
Using a caliper gauge, measure the bush bore diameter of the cylinder head.
Select a new guide bush (STD or O/S 0.05).
| Bush Bore Diameter | Bush Size |
| 10.285 to 10.306 mm (0.4049 to 0.4057 in.) | Use STD |
| 10.335 to 10.356 mm (0.4069 to 0.4077 in.) | Use O/S 0.05 |
![]() |
Heat the cylinder head to 80 to 100°C (176 to 212°F).
![]() |
Place the cylinder head on the wooden blocks.
Using SST and a hammer, tap in a new valve guide bush to the specified protrusion height.
Using a sharp 5.5 mm reamer, ream the valve guide bush to obtain the standard specified clearance.
| 5. REPLACE CONNECTING ROD SMALL END BUSH |
![]() |
Using SST and a press, press out the bush.
![]() |
Align the oil holes of a new bush and the connecting rod.
![]() |
Using SST and a press, press in the bush.
![]() |
Using a pin hole grinder, hone the bush to obtain the standard specified clearance between the bush and piston pin.
![]() |
Coat the piston pin with engine oil. Push the piston pin into the connecting rod with your thumb to check that the piston pin fits at normal room temperature.