Home › ENGINE ยท 1GR-FE › ENGINE MECHANICAL › DRIVE BELT

DRIVE BELT > INSTALLATION

for Preparation Click here



1. INSTALL DRIVE BELT


    A076442E03
  1. While turning the belt tensioner counterclockwise, align its holes, and then insert a bar with a diameter of 6 mm (0.24 in.) into the holes to fix the belt tensioner.



  1. Install the V-ribbed belt.

    HINT:
    A113028E03
    If it is hard to install the V-ribbed belt, perform the following procedure.


    1. Put the V-ribbed belt on everything except the PS pump as shown in the illustration.

    2. While releasing the belt tension by turning the belt tensioner counterclockwise, put the V-ribbed belt on the PS pump.

  1. While turning the belt tensioner counterclockwise, remove the pin.