AIRBAG SYSTEM > SRS Warning Light does not Come ON |
| 1.CHECK CONNECTION OF CONNECTOR |
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Check that the connectors are properly connected to the center airbag sensor and combination meter.
|
| ||||
| OK | |
| 2.CHECK COMBINATION METER |
![]() |
Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
Disconnect the C27 meter connector.
Turn the ignition switch ON.
Measure the voltage of the wire harness side connector.
| Tester Connection | Specified Condition |
| C27-21 - Body ground | 8 to 14 V |
|
| ||||
| OK | |
| 3.CHECK SRS WARNING LIGHT (OPERATION) |
Disconnect the A24 sensor connector with the C27 meter connector connected.
Turn the ignition switch ON.
Check that the warning light illuminates for 6 seconds after turning the ignition switch ON.
|
| ||||
| OK | |
| 4.REPLACE CENTER AIRBAG SENSOR |
Replace the center airbag sensor.
Check that the SRS warning light illuminates normally.
|
| ||||
| OK | ||
| ||