Home › BODY ELECTRICAL › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM (for Non-built-in Type Door Control Receiver)

WIRELESS DOOR LOCK CONTROL SYSTEM (for Non-built-in Type Door Control Receiver) > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. The wireless door lock control system troubleshooting procedures are based on the premise that the power door lock system is operating normally. Check the power door lock system first before troubleshooting the wireless door lock control system (Click here).
  2. Use these procedures to troubleshoot the wireless door lock control system.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      1. If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.PROBLEM SYMPTOMS TABLE
      Result: 
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B


    B.
    Go to step 5
    A


    4.OVERALL ANALYSIS AND TROUBLESHOOTING
    1. Terminals of ECU (Click here)

    2. On-vehicle Inspection (Click here)

    3. Inspection


    NEXT


    5.ADJUST, REPAIR OR REPLACE

      NEXT


      6.CONFIRMATION TEST

        NEXT

        END