Home › BODY › SEAT › FRONT SEAT ASSEMBLY (w/ Front Seat Side Airbag)

FRONT SEAT ASSEMBLY (w/ Front Seat Side Airbag) > REMOVAL

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE INNER SEAT TRACK BRACKET COVER LH
  1. Lift up the seat track handle sub-assembly LH and move the seat to the foremost position.



    B278167
  1. Using a moulding remover, detach the 2 claws and remove the inner seat track bracket cover LH.



4. REMOVE SEAT TRACK COVER LH


    B278168
  1. Using a moulding remover, detach the 2 claws and remove the seat track cover LH.



5. REMOVE FRONT SEAT HEADREST ASSEMBLY
  1. Remove the front seat headrest assembly.



6. REMOVE FRONT SEAT ASSEMBLY


    B211078
  1. Remove the 2 bolts.

  1. Lift up the seat track handle sub-assembly LH and move the seat to the rearmost position.



    B211079
  1. Remove the 2 bolts.

  1. Lift up the seat track handle sub-assembly LH and move the seat to the center position. Also, operate the reclining adjuster release handle LH and move the seatback to the upright position.

  1. Disconnect the connectors and detach the wire harness clamp from under the seat.

  1. Remove the front seat assembly from the vehicle.

    NOTICE:
    Be careful not to damage the vehicle body.