DTC P0335/13 Crankshaft Position Sensor "A" Circuit |
DTC P0339/13 Crankshaft Position Sensor "A" Circuit Intermittent |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0335/13 | No crankshaft position sensor signal to ECM at engine speed of 600 rpm or more (1 trip detection logic) |
|
| P0339/13 | In conditions (a), (b) and (c), when no crankshaft position sensor signal to ECM for 0.05 seconds or more.
|
|

| 1.INSPECT CRANKSHAFT POSITION SENSOR (RESISTANCE) |
![]() |
Disconnect the C5 sensor connector.
Measure the resistance of the sensor.
| Tester Connection | Sensor Condition | Specified Condition |
| 1 - 2 | Cold | 1,630 to 2,740 Ω |
| 1 - 2 | Hot | 2,065 to 3,225 Ω |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (CRANKSHAFT POSITION SENSOR - ECM) |
![]() |
Disconnect the C5 sensor connector.
Disconnect the E11 ECM connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| C5-1 - E11-27 (NE+) | Below 1 Ω |
| C5-2 - E11-34 (NE-) | Below 1 Ω |
| C5-1 or E11-27 (NE+) - Body ground | 10 kΩ or higher |
| C5-2 or E11-34 (NE-) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK CRANKSHAFT POSITION SENSOR (INSTALLATION) |
![]() |
Check that the crankshaft position sensor is installed correctly.
|
| ||||
| OK | |
| 4.CHECK NO. 2 CRANKSHAFT TIMING SPROCKET (TEETH OF SENSOR PLATE) |
Check that the teeth of the sensor plate do not have any cracks or deformation.
|
| ||||
| OK | ||
| ||