Home › ENGINE · 5L-E › ENGINE CONTROL SYSTEM › ECD SYSTEM

ECD SYSTEM > MIL Circuit

for Preparation Click here


DESCRIPTION

The MIL is used to inform the user when the ECM has detected a vehicle malfunction.
By turning the ignition switch ON, power is supplied to the MIL circuit, and the ECM provides the circuit ground that illuminates the MIL.
Operation of the MIL should be checked visually:
When the ignition switch is first turned ON, the MIL should illuminate. When the engine is started, the MIL should turn off.

WIRING DIAGRAM


A119280E01


INSPECTION PROCEDURE

1.CHECK MIL CONDITION

HINT:
Use the table below to troubleshoot each problem symptom.

Result:
Condition
Proceed to
MIL remains ON
A
MIL does not illuminate
B



B
Go to step 5
A


2.CHECK IF MIL TURNS OFF
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch ON and turn the tester ON.

  1. Check if DTCs have been stored (Click here). If DTCs are present, write them down.

  1. Clear the DTCs using the intelligent tester (Click here).

  1. Check that the MIL turns off.

    OK:
    The MIL turns off.



OK
REPAIR CIRCUIT INDICATED BY OUTPUT DTC
NG


3.CHECK HARNESS AND CONNECTOR (FOR SHORT)
A062417E05
  1. Disconnect the E23 ECM connector.

  1. Turn the ignition switch ON.

  1. Check that the MIL is not illuminated.

    OK:
    The MIL is not illuminated.



OK
REPLACE ECM
NG


4.CHECK HARNESS AND CONNECTOR (ECM - COMBINATION METER)
A121710E04
  1. Disconnect the E23 ECM connector.

  1. Disconnect the C27 combination meter connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    E23-5 (W) - C27-39
    Below 1 Ω
    E23-5 (W) or C27-39 - Body ground
    10 kΩ or higher



OK
REPAIR OR REPLACE HARNESS OR CONNECTOR
NG

REPLACE COMBINATION METER 

5.CHECK IF MIL ILLUMINATES
  1. Check that the MIL illuminates when turning the ignition switch ON.

    OK:
    The MIL illuminates.



OK
NORMAL
NG


6.INSPECT COMBINATION METER (MIL CIRCUIT)
  1. See the combination meter troubleshooting procedures (Click here).



NG
REPAIR OR REPLACE COMBINATION METER
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR (COMBINATION METER - ECM)