Home › DRIVE LINE › PROPELLER SHAFT › PROPELLER SHAFT ASSEMBLY (for TSAM Made)

PROPELLER SHAFT ASSEMBLY (for TSAM Made) > REMOVAL

for Preparation Click here



1. REMOVE PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY (for Pre-Runner)


C119752E01
  1. Place matchmarks on the propeller shaft flange and differential flange.

  1. Remove the 4 nuts, 4 bolts and 4 washers, and disconnect the propeller shaft.



    C118612
  1. Remove the center support bearing's 2 set bolts and 2 plates from the frame crossmember.



    C098710E01
  1. Pull out the propeller shaft.

  1. Install SST in the transmission to prevent oil leakage.

    SST
    09325-40010  



2. REMOVE REAR PROPELLER SHAFT ASSEMBLY (for 4WD)


C118613E01
  1. Place matchmarks on the propeller shaft flange and transfer flange.

  1. Remove the 4 nuts and 4 washers, and disconnect the propeller shaft.



    C118614E01
  1. Place matchmarks on the propeller shaft flange and differential flange.

  1. Remove the 4 nuts, 4 bolts and 4 washers.

  1. Remove the propeller shaft.



3. INSPECT UNIVERSAL JOINT SPIDER ASSEMBLY
  1. Check the spider bearings for wear or damage.

  1. Check each spider bearing's axial play by turning the yoke while holding the shaft tightly.

    Maximum bearing axial play:
    0 to 0.05 mm (0 to 0.002 in.)

    If the axial play is greater than the maximum, replace the spider bearing.