Home › SUSPENSION & AXLE › AXLE › FRONT AXLE HUB BOLT

FRONT AXLE HUB BOLT > REPLACEMENT

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.
  3. A bolt without a torque specification is shown in the standard bolt chart (Click here).



1. DISCONNECT FRONT WHEEL


2. REMOVE FRONT DISC BRAKE CYLINDER ASSEMBLY LH


F042731E01
  1. Remove the bolt and disconnect the brake tube bracket from the steering knuckle.



    C111186
  1. Remove the 2 bolts and disconnect the disc brake cylinder.

  1. Support the brake caliper securely.



3. REMOVE FRONT DISC


4. REMOVE FRONT AXLE HUB BOLT


F044194E01
  1. Temporarily install 2 nuts to the hub bolts as shown in the illustration.

  1. Using SST and a screwdriver, remove the hub bolt.

    SST
    09650-17011  



5. INSTALL FRONT AXLE HUB BOLT


C098706E01
  1. Temporarily install a plate washer and nut to a new hub bolt as shown in the illustration.

  1. Using a screwdriver to hold the front axle, install the hub bolt by tightening the nut. Then remove the nut and plate washer.

  1. Remove the 2 nuts from the hub bolts.



6. INSTALL FRONT DISC


7. CONNECT FRONT DISC BRAKE CYLINDER ASSEMBLY LH


C111186
  1. Connect the disc brake cylinder with the 2 bolts.

    Torque:
    123 N*m{ 1,254 kgf*cm , 91 ft.*lbf }



    F042731E01
  1. Connect the brake tube bracket to the steering knuckle with the bolt.

    Torque:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }



8. INSTALL FRONT WHEEL

Torque:
105 N*m{ 1,071 kgf*cm , 77 ft.*lbf }