Home › BRAKE › BRAKE CONTROL › ANTI-LOCK BRAKE SYSTEM

ANTI-LOCK BRAKE SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here


HINT:
  1. Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  1. Inspect the fuses and relays related to this system before inspecting the suspected areas below.

NOTICE:
When replacing the skid control ECU, sensor, etc., turn the ignition switch OFF.


Anti-lock brake system 
Symptom
Suspected Area
See page
ABS does not opera
IG power source circuit
Click here
Front speed sensor circuit
Click here
Rear speed sensor circuit
Click here
Brake actuator (hydraulic circuit)
Click here
When above areas are all normal but problem still occurs, replace skid control ECU
-
ABS does not operate proper
Front speed sensor circuit
Click here
Rear speed sensor circuit
Click here
Stop light switch circuit
Click here
Brake actuator (hydraulic circuit)
Click here
When above areas are all normal but problem still occurs, replace skid control ECU
-
ABS warning light malfunction
Refer to ABS Warning Light Remains ON
Click here
Refer to ABS Warning Light does not Come ON
Click here
Skid control ECU
-
DTC check cannot be performed
Refer to ABS Warning Light Remains ON
Click here
Refer to ABS Warning Light does not Come ON
Click here
TC and CG terminal circuit
Click here
When above areas are normal but problem still occurs, replace skid control ECU
-
Speed sensor signal check cannot be performed
TS and CG terminal circuit
Click here
Skid control ECU
-